ICOM Rig Control Interface CI-V
AMD-CI-V Ver2.0
This is the interface to read the frequency or mode and to control the RIG from PC for ICOM Rig.
It is connect between the serial interface of PC and CI-V 3.5mm connector of ICOM Rig
This interface is assembled in the DSUB 9 pins connector for serial communication
The parts in this interface is used the discrete parts instead of the chip parts to make easy.
It needs not the external power supply.

AMD-CI-V Ver2.0 parts list
parts namevalueNo.
resistor3.3K Ohm1
resistor10K Ohm3
diodefor small signal 5mm pitch2
transistor2SC1815 compatible2
connectorDSUB 9Pins(famale)1
case for connectorfor DSUB 9pins1
shield cable1 center wirearound 3 feet
mini jackmonoral 3.5mm1
PCBAMD-CI-V Ver2.01
ICOM Rig Control Interface CI-V
AMD-CI-V Ver1.0
This is the interface to read the frequency or mode and to control the RIG from PC for ICOM Rig.
It is connect between the serial interface of PC and CI-V 3.5mm connector of ICOM Rig
This interface is assembled in the DSUB 9 pins connector for serial communication
The parts in this interface is used the chip parts.
It needs not the external power supply.
AMD-CI-V Ver1.0 parts list
parts namevalueNo.
chip resistor3.3K Ohm1
chip resistor10K Ohm3
chip diodefor small signal2
chip transistorfor small signal2
connectorDSUB 9Pins(famale)1
case for connectorfor DSUB 9pins1
shield cable1 center wirearound 3 feet
mini jackmonoral 3.5mm1
PCBAMD-CI-V Ver1.01
How to set the ZlogWin for contest
Start ZlogWin
Select [Windows]->[Options]->[Hardware],and it shows as following.
Set [Rig1] of [Ports]
Select the RS232C (e.g. COM1)
Select the Rig as IC-706
Click [OK]

[Select [Windows]->[Options]->[Rig_control],and it shows as following.

It shows the frequency and mode of the ICOM Rig
The following shows the frequency 7MHz and mode CW

If you change the Frequency or the mode on PC,then the Frequency or the mode of Rig will change.
e-mail:n2amd@arrl.net
Retuen to the top page